Power Linking; Battery Charge Notes; Dmx Linking; Infrared Remote Control (Irc) - Chauvet Professional Well Fit Guía De Referencia Rápida

Power Linking

You can link up to 5 WELL Fit products at 120 VAC, 9 products at 208 VAC, or 9 at 230 VAC. Never exceed this number.
Power linking cords can be purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Replacing the Fuse
The WELL Fit has no external fuse. However, the road case charger comes with a replaceable fuse.
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

Battery Charge Notes

This product is equipped with a built-in rechargeable lithium ion battery.
• Avoid depleting the battery below 10%.
• For best results, charge the battery in a temperature between 32 ºF (0 ºC), and 95 ºF (35 ºC).
• When charging the battery, keep the product at least 1 m from any open flame or hot plate.
• If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. Allow a depleted battery to charge for a few minutes before turning on the device.
• While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
• It is not recommended to close the road case cover while charging the battery unless the procedure is
monitored.
• Always charge the battery with the product in an upright position.
• Do not charge the battery for more than 24 hours
Storage Notes
• Store charged product(s) in a dry environment, away from direct sunlight.
• Charge or discharge the battery to approximately 50% of capacity before storage.
• Lithium-Ion batteries continue to slowly discharge (self-discharge) when not in use or while in storage. Routinely
check the battery's charge status
• Store the battery at temperatures between 41 °F and 68 °F (5 °C and 20 °C).
• Always store the product in an upright position (≤ 10° tilt)
CAUTION: The power switch must be in the off position before placing the product in the charging
case.

DMX Linking

The WELL Fit will work with a DMX controller using a wireless DMX connection. A DMX Primer is available from
www.chauvetprofessional.com.
DMX Connection
The WELL Fit uses a wireless DMX data connection for its DMX personalities: 4 Ch, 6 Ch, 10Ch, HSI and HSV. See the
User Manual for information about connecting and configuring the product for DMX operation

Infrared Remote Control (IRC)

The WELL Fit is fully compatible with the Infrared Remote Control (IRC) from CHAUVET. For more information on the
IRC, download the User Manual from www.chauvetprofessional.com.
It may be necessary to turn the product off and on again when switching from W-DMX to IRC and
vise-versa.
WELL Fit QRG Rev. 6
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
.
.
EN
Screw Color
Yellow/Brass
Silver
Green
.
.
2