Dmx Linking - Chauvet Professional ROGUE R2X SPOT Guía De Referencia Rápida

Rogue R2X Spot QRG
AC Power
Power Linking
AC Plug
Replacing The Fuse

DMX Linking

DMX Connection
RDM (Remote
Device
Management)
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
You can link up to 5 Rogue R2X Spot products at 120 V, 8 products at 208 V, or 9
products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Rogue R2X Spot will work with a DMX controller using a 3- or 5-pin DMX
data connection. A DMX Primer is available from www.chauvetprofessional.com.
The Rogue R2X Spot uses a 3- or 5-pin DMX data connection for its DMX
personalities: 18CH and 21CH. See the User Manual for information about
connecting and configuring the product for DMX operation.
Remote Device Management, or RDM, is a standard for allowing DMX-enabled
devices to communicate bi-directionally along existing DMX cabling. Check the
DMX controller's User Manual or with the manufacturer as not all DMX
controllers have this capability. The Rogue R2X Spot supports RDM protocol that
allows feedback to make changes to menu map options. Download the User
Manual from www.chauvetprofessional.com
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
for more details.
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
EN