Rena Filstar xP Serie Guía De Uso página 13

C O N N E C T I O N
1 The inlet connection on the filter is
marked by the drawing
colour of the accessories one (light grey).
2 Measure the flexible tubing that is
attached to the Inlet Assembly, mark with
a pen.
I
I
T O
3
and by the same
Note: It is very important NOT to cut the
tubing too short. If the tubing is cut too
short and creates tension on the quick
disconnect valve, the filter may leak.
Additionally, leaving the tubing too long
may prevent the filter from priming and
greatly reduce the waterflow.
4
the Quick Disconnet Valve. This inlet
connection on the filter is marked by the
drawing
Secure the Flexible Tubing with a Flexible
Tubing Clamp.
T H E F I L T E R
Add 4" (10 cm) to this mark and cut.
Push the tube onto the water inlet of
and by the light grey colour.
I
I
US
13