(FI G. 5) - Ariston 3318590 Instrucciones Para La Instalación Y El Uso

installation (wireless version)
GB
(for versions 1138591 - 3318602 only)
In order to function properly, the wireless
timer-thermostat must be combined
with a receiver. The timer-thermostat -
receiver combination is preconfi gured by
the manufacturer; this means that the
devices must be operated in the same
location.
RECEPTION TEST
In order to verify the correct signal trans-
mission, power the timer-thermostat by
inserting the batteries supplied with the
kit, as mentioned previously. Keep the
timer-thermostat roughly 2-3 metres away
from the receiver and perform the proce-
dure outlined in the receiver instruction
manual.
After completing the test, proceed with the
timer-thermostat installation.
Fitting the device to the wall
- Fix the timer-thermostat base to the
wall in the chosen position, using the
screws supplied with the kit (Fig. 1, 2).
- Position the timer-thermostat onto the
base and push it downwards (Fig. 3).
Fitting the table-top version
- Fix the support to the base (Fig. 4).
- Position the timer-thermostat onto the
base and push it delicately downwards
(Fig. 5).
NOTE:
If the green LED on the receiver does
not fl ash or if the red LED does not turn
on, one of the components of the system
(timer-thermostat and receiver) has been
swapped around or replaced.
At this stage, read the receiver instructions
for the reconnection procedure.
30
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)