Cut Exterior - Petsafe PPA11-10915 Manual De Instalación

Fit
3C. Using the A side of the pet door, check
Check
the fit. Do not force fit if it is tight.
3D. If the hole is too small, simply remove the pet door
and re-cut or file the hole slightly to enlarge. Do
not cut more than ⅛" (3.2 mm) from your previous
cut. Once the pet door properly goes into the hole,
adjust to ensure the unit is square.
Step 4

Cut Exterior

4A. Remove the pet door from the wall. Fold up the
Center Locator.
4B. Slide the folded piece into the back of A side as
shown.
4C. Place A side of pet door back into wall and use the
drywall screws to hold unit in place temporarily.
4D. Lift the flap and push the
Center Locator until it is
touching the outside wall.
Make sure all the folded
flaps are resting flush on
the inside of tunnel and
that you have not
completely pushed Center
Locator out of pet door.
Mark the holes on the
Center Locator.
4E. Remove the pet door from the inside wall. Drill out the
marked holes with your
keep these holes as straight as possible.
Helpful Tip: Use both hands to hold drill steady and straight
at a 90° angle.
6
4C
⁄ " (8mm) drill bit. Be careful to
5
16
1-800-732-2677
3C
4A
4D
4E
3D
4B