REV Ritter EMT707CTLA Manual Del Usuario página 8

GB
ASSEMBLY
The power calculator is plugged directly into the socket. Pay attention to
safety instructions!
HANDLING
1. Connect the device to the mains.
2. The display shows all features and changes into the cost mode after
3 seconds. The last value before the power cut-off is shown.
3. Press the button „SET" to adjust the tariff or the KWH. Firstly the tariff is
shown and then the KWH, if the button is pushed again.
4. Firstly the right digit blinks, which can be changed by pushing the
button „". The value can be changed by pushing the Button „+".
5. Finish the setting by pushing the „MENU"-button.
6. Plug in the desired consumer.
Note:
The reset-button conduces to restart the device, whereas the cost, tariff
and KWH will not be deleted. The cost and the KWH can be cancelled by
manual input of the value 0.
TROUBLE SHOOTING
Problem
Display - no display
CARE ADVICES
• Cleaning only with a dry sheet.
TECHNICAL DATES
Voltage (U):
Current (I):
Accuracy:
Display: Voltage:
Electricity:
Line:
kWh:
Measurement category:
8
Task
Reset (RST) to perform
230V~/50Hz
16A
+/- 10% (> 25W)
+/- 5% (> 100W)
200V~ - 250V~
0,00A - 16,0A
0VA - 3680VA
0,0kWh - 9999,9kWh
CATII