Sevylor POINTER K1 Manual De Utilización página 6

Water will enter between the outer hull and inside chambers, this is O.K ; however, whenever you take this
item out of the water and deflate it, allow for it to air out and dry, neither the skin/hull or the inside chambers
will suffer from water damage, but stagnant water could cause mildew and foul odor.
HOW TO REPAIR SMALL PUNCTURES
You can repair small punctures with the included repair kit (Note: Glue not included in USA). Please note that in order for
the repair to be successful, the humidity level should be less than 60%, temperature between 65° F/77° F or 18° C/25° C.
Avoid carrying out repairs in the rain or in direct sunlight.
Remove the inside tube from the hull. Check that the tube is fully deflated and lies flat.
1. Draw the shape of the patch exactly where it will be applied, cut a round patch at least 2" / 5 cm larger than the
cut/damaged area.
2. Clean the damaged area and the corresponding side of the patch with a grease remover of the alcohol type and allow
for it to dry for 5 minutes.
3. Apply 3 thin layers of glue on both the patch and the damaged area, allow for it to dry for 5 minutes between layers
until the glue feels tacky.
4. When the third layer of glue is dry, apply the patch without pressing and adjust the positioning if required, press the air
bubbles which may have formed under the patch by smoothing the patch with a round object such as a spoon, do this
procedure by starting in the center of the patch towards the outside, clean the excess glue with a solvent. Drying : 12
hours.
Perform all of your repairs in a well-ventilated area.
Avoid inhaling glue vapors or swallowing.
N.B. the repairs on the weldings must not be glued. Only the manufacturer of the boat can perform the repairs on the
E
weldings.
N
WARRANTY
G
L
Sevylor warrants (legal warranty) to the original purchaser only, and from date of purchase, when any product is used for
I
normal recreational purposes, that the product is free from defects (weldings). Check with your local Sevylor office for
S
warranty duration details, which vary for different countries. The warranty does not cover any puncture, cut or abrasion
H
sustained in normal use or damage from unreasonable uses or improper storage.
If any product is found to be defective, the owner may return it to the store it was purchased from with the
original sales receipt.
After inspection of any product found defective, Sevylor shall either repair or replace the defective part or item as deemed
necessary by Sevylor.
Sevylor shall not be held liable for incidental and consequential damages.
There are no warranties which extend beyond the description of the face hereof.
This warranty is inclusive in lieu of all other warranties.
This warranty gives you specific legal rights and you may also have other rights, which may vary, from country to country.
The main limitations to the application of the warranty are the following :
The item must not be modified and/or fitted with a motor in excess of that allowable by the manufacturer or
•
used in any activities outside normal recreational use (such as races, rental, professional usage).
Use in excess of the manufacturers recommended maximum load capacity.
•
Pressure recommendations, assembly / disassembly and handling procedures must be strictly observed.
•
The maintenance and the storage procedures must not be neglected.
•
This warranty does not cover parts and accessories not supplied or recommended by the manufacturer or
•
defects resulting from the installation of such equipment on their products.
NOTICE : all repairs covered by warranty must be performed by Sevylor.
Your product is designed in accordance with the standards for a specific use. Any modifications,
transformations or use of a motor horse power higher than indicated by the manufacturer could result in serious
risks for the user and will void the warranty.
WARNING !
WARNING !
Avoid contact with the skin or the eyes.
Keep all repair materials (glue, solvents, etc.)
away from children's reach.
WARNING !
6