Lifting
Hook
Removable
front access
panel
Position fork lift
under pallet
For final positioning with pallet
removed, fork lift points are under
the transformer. Forks must be
inserted all the way through the
depth.
FIGURE 5
Typical Type 4 & 12, NH Series Non-Ventilated Enclosure
Assembly for Three Phase or Single Phase Transformers.
Notes:
1. Handling - units are designed to be raised by a fork lift
2. Shipping - units are shipped on pallets which are to be
3. Installation - This is a non-ventilated indoor or outdoor
Recommended cable
entry location (either
side). Refer to outline
drawing for exact
dimensions.
4. All general purpose/drive isolation transformers should be
from underneath the pallet. Final positioning of the unit
with the pallet removed can be via a fork lift under the
transformer with the forks between the channels or with
the lifting hooks if provided.
removed at installation.
enclosure designed primarily to provide a degree of
protection against falling dirt, rain, sleet, snow,
windblown dust, splashing water, hose-directed water and
that will
be undamaged by the external formation of
ice on the enclosure. It is suitable in areas where exposure
to large amounts water from any direction is possible.
(Note: not submersible)
located away from any wall or any other obstruction,
please refer to the nameplate for the minimum distance.
19
IOMGDDI / September 2017