FAAC TM2 ERX Manual De Instrucciones página 30

EXAMPLE 1:
Setting first the opening position
SETTING THE OPENING POSITION
If the rolling shutter is completely open, you have first to drive it down by around
20 cm.
Hold the button A or C pressed and drive the rolling shutter to the opening position.
With physical stops: press button A or C until the motor stops automatically.
Without physical stops: use the button A or C to drive the rolling shutter to the
necessary opening position.
To set the opening position, press buttons A (up) and B (stop) simultaneously for
about 2 seconds, until the motor automatically performs a short "down" movement.
This move is the visual confirmation of the setting operation.
Tn: Already programmed remote control
A
+
? A B
C
Tn Tn (2 sec) confi rm
SETTING THE CLOSING POSITION
Pressing now the button C, drive completely down the rolling shutter to the closing
position.
With lockdown hangers: press button C until the motor stops automatically.
Without lockdown hangers: use the button A or C to drive the rolling shutter to
the necessary closing position.
To set the closing position, press buttons B (stop) and C (down) simultaneously for
about 2 seconds, until the motor automatically performs a short "up" movement.
This move is the visual confirmation of the setting operation.
Tn: Already programmed remote control
+
B C
C
Tn Tn (2 sec) confi rm
TM2 ERX 30 A4518_6G41_Rev.A