FAAC TM2 ERX Manual De Instrucciones página 31

EXAMPLE 2:
Setting first the closing position
SETTING THE CLOSING POSITION
If the rolling shutter is completely closed, you have first to drive it up by around 20
cm.
Hold the button A or C pressed and drive the rolling shutter to the closing position.
With lockdown hangers: press buttons A or C until the motor stops automatically.
Without lock down hangers: use the button A or C to drive the rolling shutter to
the necessary closing position.
To set the closing position, press buttons B (stop) and C (down) simultaneously
for about 2 seconds, until the motor performs automatically a short "up" move-
ment.
This move is the visual confirmation of the setting operation.
Tn: Already programmed remote control
A
?
+
B C
C
Tn confi rm
Tn (2 sec)
SETTING THE OPENING POSITION
Pressing now button A, drive completely up the rolling shutter to the opening
position.
With physical stops: press button A until the motor stops automatically.
Without physical stops: use the button A or C to drive the rolling shutter to the
necessary opening position.
To set the opening position, press buttons A (up) and B (stop) simultaneously
for about 2 seconds, until the motor automatically performs a short "down"
movement.
This move is the visual confirmation of the setting operation.
Tn: Already programmed remote control
A
+
A B
Tn (2 sec)
Tn
confi rm
TM2 ERX 31 A4518_6G41_Rev.A