GE Current Evolve EFH1 Guia De Instalacion página 2

1
UNPACKING/HANDLING
• Inspect luminaire to confirm no damage has occured
during transit.
• To aviod damage, do not impact or stack luminaire
after removal from packaging.
2
MOUNTING
2a. Pipe Mount:
Mount on vertical 1-7/8 to 2-3/8-inch
O.D. or 2-3/8 to 3-inch O.D. pipes.
• Pipe must point upward such that gavity acts to hold
luminaire on pipe end.
• Tighten Knuckle Bolt to 25 - 30 ft-lbs (34 - 40.8 N-m)
torque after aiming.
• Do not mount unit upside down.
• Tighten set screws to 25 - 30 ft-lbs (34 - 40.8 N-m) of
torque.
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 30 ft-lbs (40.8 N-m) of torque on
set screws or knuckle bolt.
2b. Wall Mount:
Mount to vertical surface using four
0.43-inch clearance holes spaced 4.37(H) x 2.87(V) inches
with customer supplied fasteners/anchors.
• Seal wall mount flange to the mounting surface
with silicone caulk or equivalent.
• Tighten Knuckle Bolt to 25 - 30 ft-lbs (34 - 40.8 N-m)
torque after aiming.
WARNING
Risk of injury or damage. Unit will fall if not installed properly.
Do NOT exceed 30 ft-lbs (40.8 N-m) of torque on knuckle bolt.
2c. Trunion Mount:
Mount on a flat surface using a
customer supplied 3/4-inch bolt through the clearnace
hole provided in the trunion bottom.
• Tighten two (2) side Trunion Bolts to 25 - 30 ft-lbs
(34 - 40.8 N-m) torque after aiming.
• If desired, trunion can be secured against rotation
by using customer supplied fastner(s) through
additional clearance holes in the trunion bottom.
WARNING
Risk of injury or damage. Unit will fall if not installed properly.
Do NOT exceed 30 ft-lbs (40.8 N-m) of torque on knuckle bolt.
FIGURE 1a. Pipe Mount
2.875 in.
FIGURE 2b. Wall Mount
4 Holes
.4387 in.
FIGURE 2c.
Trunion Mount
Provision for Customer
Supplied 3/4" Bolt
Knuckle Bolt
Wiring Cover
Set Screws
Door
Hinge
Wiring Cover
Knuckle Bolt
4.375 in.
Top Closure Screw
Trunion
Bolt