Installation And Mounting; Quick Start - Peavey GPS Serie Guía De Operación

Please read this guide in its entirety. Pay close attention to the various warnings within as they pertain to the
safety of you and your product. Each section will begin with a short description of the information you can
expect to obtain within. This should help you to locate the material you are looking for in a timely manner.
Once again, congratulations and thank you for buying Peavey!
UNPACKING/REGISTRATION
Inspect the amplifier during unpacking. If you find any damage, notify your dealer immediately. Be sure to
save the carton and all packing materials. Should you ever need to ship the unit back to Peavey Electronics,
one of its service centers, or the dealer, use only the original factory packing. Please fill out your registration
card at this time. It is important that you complete the entire form and mail it to Peavey Electronics in order
for your warranty to apply.

INSTALLATION AND MOUNTING

GPS Series amplifiers are 2-rack-space units that mount in a standard 19-inch rack. On all amplifiers, four
front panel mounting holes are provided. Refer to the specifications for your specific model in this manual.

QUICK START

The following section lists the steps for basic usage. This is only a quick reference. It is very important that
you read the entire manual in order to ensure the safe and optimum operation of your GPS Series amplifier.
TO SET UP THE AMPLIFIER FOR BASIC USAGE:
1. Rack mount the amplifier in the location where it is to be used, remembering to allow for adequate
access and cooling space. For more information, see the section on Cooling Requirements.
2. Make input connections, balanced or unbalanced, to the combination input connector on the rear panel.
See the sections on The INs and OUTs of MODE SELECTION for more information.
3. Connect speakers to the output jacks or binding posts. Be sure to make the correct output connections
for stereo or bridged mono configuration. See the section on The INs and OUTs of MODE
SELECTION for more information.
4. Make power connections, allowing for proper current draw. See the section on AC Mains Circuit Size
Requirements for more information.
5. Turn down (fully counterclockwise) the two gain attenuators on the front panel. Turn the front panel
AC switch to "ON," and bring up the gain attenuators to the desired levels.
AC POWER
The following section will describe the AC power features of your GPS Series amplifier. AC power is a
critical element in power amplification. Please read this section carefully, paying special attention to any
warning signs. Refer to the diagram below and on page 8 to locate these features. Refer to page 7 for operation
notes regarding AC power.
NOTE: Always make connections to your GPS Series amplifier while the unit is turned off.
1. REMOVABLE AC POWER CORD (Located on the rear of the unit)
This receptacle is for the IEC line cord (included), which provides AC power to the unit. Connect the
line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur
if an improper line voltage is used. (See voltage marking on unit.) Never remove or cut the ground pin
of the line cord plug. This unit is supplied with a properly rated line cord. When lost or damaged,
replace this cord with one of the proper ratings.
4