Removing The Outer Casing - HouseWarmer HW500GW Serie Instrucciones De Instalación Y Manual Del Propietario

1. When optional blower is not installed. At the top of
the outer casing, remove one (1) screw from the center
clearance slot that attaches the outer casing to the header
assembly.
When optional blower is installed. Remove four (4)
screws that attach blower front to blower housing. Separate
blower front from blower housing. Remove blower front
by disconnecting fan control switch wire assembly from
power cord and motor wire. Remove two (2) screws from
the outside clearance slots that attach the outer casing to the
header assembly.
23813-1-0807

REMOVING THE OUTER CASING

Figure 27
Figure 28
2. Open casing door. Remove two (2) screws that attach
bottom of outer casing to inner casing.
3. Remove outer casing from unit and place aside.
Figure 29
Figure 30
Page 15