Lighting Instructions; To Turn Off Gas To Appliance - HouseWarmer HW500GW Serie Instrucciones De Instalación Y Manual Del Propietario

Calefactor de pared doble con ventilación por gravedad
Tabla de contenido

Publicidad

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
1. STOP! Read the safety information above.
2. S e t
t h e
t h e r m o s t a t
3. Turn off all electric power to the appliance (if appli-
cable).
4. Push in gas control knob slightly and turn
clockwise
GAS CONTROL KNOB SHOWN IN "OFF" POSITION
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
5. Wait ten (10) minutes
Then smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information above.
If you don't smell gas, go to the next step.
1. Set the thermostat to lowest setting.
2. Turn off all electric power (if applicable) to
appliance if service is to be performed.
Page 18

LIGHTING INSTRUCTIONS

causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
t o
l o w e s t
s e t t i n g .
to "OFF."
to clear out any gas.

TO TURN OFF GAS TO APPLIANCE

• If you cannot reach your gas supplier, call the fire depart-
ment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it; call a qualified service tech-
nician. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
6. Find pilot - follow metal tube
from gas control. The pilot is mounted
on front of main burner.
7. Turn gas control knob coun-
terclockwise
8. Push and hold control knob in and repeat-
edly push the ignitor button ungil pilot is lit (or use a
match to light). Continue to hold the control knob in
for about one (1) minute after the pilot is lit. Release
knob and it will pop back up. Pilot should remain lit.
If it goes out, repeat steps 4 through 8.
• If knob does not pop up when released, stop and
immediately call a qualified service technician or
gas supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
9. Turn gas control knob counterclockwise
"ON."
10. Turn on all electric power to the appliance
(if applicable).
11. Set thermostat to desired setting.
3. Push in gas control
clockwise
to "OFF." Do not force.
to "PILOT."
knob slightly and turn
23813-1-0807
to

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hw500gw0 1n-1 serieHw500gw0 1p-1 serie

Tabla de contenido