Cedar Ridge MD3TPF Manual Del Usaurio página 13

Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on back panel
of heater (see Figure 10).
2. Place heater onto mounting bracket. Slide
horizontal slots onto stand-out tabs on
mounting bracket.
Figure 10 - Mounting Heater Onto
Mounting Bracket
This appliance is factory
preset for propane/LP gas.
No changes are required for
connecting to propane/LP.
Only a qualified installer or
service technician can perform
gas selection and connecting to
gas supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited. The access plate
to the simple switching means
shall not be opened while the
heater is in operation.
200033-01B
INSTALLATION
Horizontal Slots
GAS SELECTION
www.usaprocom.com
INSTALLING BASE FEET
Before installing heater to the base, please
make sure you have the following items:
(2) Base Feet
(4) Sheet Metal Screws
Installation Procedure:
1. Set back of heater on table with the bot-
tom of heater extending outside the table
edge.
2. Fasten base feet to heater using sheet
metal screws.
Base
Feet
Sheet Metal Screws
Figure 11 - Installing Base Feet
CAUTION: To avoid gas
leakage at the inlet of regulator,
a qualified installer or service
technician must use supplied
hex plug with sealant.
WARNING: Do not attempt to
access or change the setting of
the fuel selection means.
Access to and adjustment of the fuel selection
means must only be performed by a qualified
service person when connecting this appliance to
a specified fuel supply at the time of installation.
Change of the selector setting to other than
the fuel type specified at the time of installa-
tion could damage this appliance and render
it inoperable.
The installer shall replace the access cover
before completing the installation and operat-
ing this appliance.
13