Sanus VLC1 Manual De Instrucciones página 13

STEP 2C Attach Wall Plate
Min. 16 in.
(406 mm)
Min.
1/2 in.
(13 mm)
CAUTION
: Avoid potential personal
injuries and property damage!
●
Studs must be at least 2 x4 in. / 25 ga.
●
Stud type and structural strength
must conform to the North American
Specification for the Design of Cold-Formed
Steel Structural Members
[362 S 125 18, C-Shape, S - Stud Section].
●
If back side of wall is unfinished, drywall
must be installed to a minimum of one stud
left and right of the stud(s) being used to
install the mount.
●
Drywall must be a minimum of 1/2 in. (13 mm)
thick on each side of the studs, and a
minimum clearance of 1 7/8 in. (48 mm)
behind the wall is required.
● Drywall must be secured to studs with
screws 12 in. (304.8 mm) on center.
●
Stud centers must be verified.
Steel Stud Installation
*
Steel Stud Anchor Kit is NOT INCLUDED
Contact Customer Service at 1-800-359-5520 to have
the additional hardware shipped directly to you.
1. Locate the studs using the Sanus magnetic stud finder
studs using the probe of the stud finder
2. Place wall plate at your desired height and position over your studs. Level wall plate
09
and tape in place.
CAUTION
: Avoid potential personal injuries and property damage! DO NOT use the
three middle slots in the wall plate for mounting.
1
10
. Mark the centers of the studs with a pencil.
10
2
09
CAUTION
: DO NOT use the three
middle slots in the wall plate for mounting.
provided. Find the edges of the
09
13