Problem: Hour is incorrect (minute and date are
correct)
Solution:
Be sure correct time zone and daylight saving time
settings are selected.
Problem: The LCD is faint
Solution:
1) Set the LCD contrast to a higher number
2) Replace batteries
Problem: No outdoor temperature is displayed.
Solution:
1) Remove all batteries, reinsert into remote
temperature sensor first, then display.
2) Place remote sender closer to display.
3) Be sure all batteries are fresh.
4) Place Remote Control Sender and Temperature
station in position so the straight-line signal is
not passing through more than two or three walls.
Problem: Temperatures do not match if units are
placed next to each other.
Solution:
Each temperature sensor is manufactured to be
accurate to within 1 degree plus or minus and under
normal conditions, so two sensors could be as much
as 2 degrees different. However, the difference can
be exaggerated further because the sensors are
designed for different working environments. The
indoor sensor is less responsive to ambient air
currents because of the shielding effect of the
display's case. In addition, the case can act as a
heat sink to absorb and store heat from external
sources (i.e. handling of the case or radiant heat).
Also, the much greater range of the outdoor
temperature sensor requires a different calibration
GB
P.22
Outdoor Temperature reception (Temperature
station):
Every 5 minutes.
Transmission Range:
80 feet (in open space).
Power Supply:
Temperature station:
2 x AA, IEC LR6, 1.5V.
Remote Temperature Sensor: 2 x AA, IEC LR6, 1.5V.
Battery life cycle:
Approximately 12 months.
Recommended battery type: Alkaline.
Dimensions (H x W x D)
Temperature station
7.48" x 2.95" x 1.18"
Remote Temperature Sensor
5.04" x 1.57 x 0.9"
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited
warranty on this product against manufacturing
defects in materials and workmanship.
This limited warranty begins on the original date of
purchase, is valid only on products purchased and
used in North America and only to the original
purchaser of this product. To receive warranty
service, the purchaser must contact La Crosse
Technology, Ltd for problem determination and
service procedures. Warranty service can only be
perfor med by a La Crosse Technology, Ltd
authorized service center. The original dated bill of
sale must be presented upon request as proof of
purchase to La Crosse Technology, Ltd or La Crosse
Technology, Ltd's authorized service center.
La Crosse Technology, Ltd will repair or replace this
product, at our option and at no charge as stipulated
herein, with new or reconditioned parts or products
if found to be defective during the limited warranty
period specified above. All replaced parts and
products become the property of La Crosse
Technology, Ltd and must be returned to La Crosse
Technology, Ltd. Replacement parts and products
GB
P.24
curve than the indoor range. Error is usually greater
at the extreme ends of a range, making it harder to
compare different ranges with different curves.
Under non-laboratory conditions, it is difficult to
compensate for the above factors and obtain an
accurate comparison.
MAINTENANCE AND CARE INSTRUCTIONS
•
Extreme temperatures, vibration, and shock
should be avoided to prevent damage to the units.
•
Clean displays and units with a soft, damp cloth.
Do not use solvents or scouring agents; they may
mark the displays and casings.
•
Do not submerge in water.
•
Immediately remove all low powered batteries
to avoid leakage and damage.
•
Opening the casings invalidates the warranty. Do
not try to repair the unit. Contact La Crosse
Technology for repairs.
SPECIFICATIONS
Temperature Measuring Range:
Indoor: 14.2˚F to 139.8˚F with 0.2˚F resolution.
(-9.9˚C to 59.9˚C with 0.1˚C resolution).
"OFL" displayed if outside this range.
Outdoor: -21.8˚F to 157.8˚F with 0.2˚F resolution.
(-29.9˚C to 69.9˚C with 0.1˚C resolution).
"OFL" displayed if outside this range.
Humidity Measuring Range
Indoor relative humidity measuring range:
1% to 99% with 1% resolution.
("- -" displayed if outside this range.
Indoor Temperature checking interval:
Every 10 seconds.
Indoor Humidity checking interval:
Every 1 minute.
Outdoor Temperature checking interval (Remote
Temperature Sensor):Every 1 minute.
assume the remaining original warranty, or ninety
(90) days, whichever is longer. La Crosse
Technology, Ltd will pay all expenses for labor and
materials for all repairs covered by this warranty. If
necessary repairs are not covered by this warranty,
or if a product is examined which is not in need or
repair, you will be charged for the repairs or
examination. The owner must pay any shipping
charges incurred in getting your La Crosse
Technology, Ltd product to a La Crosse Technology,
Ltd author ized ser vice center. La Crosse
Technology, Ltd will pay reasonable return shipping
charges to the owner of the product.
Your La Crosse Technology, Ltd warranty covers all
defects in material and workmanship with the
following specified exceptions: (1) damage caused
by accident, unreasonable use or neglect (including
the lack of reasonable and necessary maintenance);
(2) damage occurring during shipment (claims must
be presented to the carrier); (3) damage to, or
deterioration of, any accessory or decorative
surface; (4) damage resulting from failure to follow
instructions contained in your owner's manual; (5)
damage resulting from the performance of repairs
or alterations by someone other than an authorized
La Crosse Technology, Ltd authorized service
center; (6) units used for other than home use (7)
applications and uses that this product was not
intended or (8) the products inability to receive a
signal due to any source of interference.. This
warranty covers only actual defects within the
product itself, and does not cover the cost of
installation or removal from a fixed installation,
normal set-up or adjustments, claims based on
misrepresentation by the seller or performance
variations resulting from installation-related
circumstances.
GB
P.23
GB
P.25