Publicidad
Idiomas disponibles
Idiomas disponibles
Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of self-clean, in case if not have this
button change the steam control to the maximum position.
Boiling water and steam will be ejected from the holes in soleplate with impurities washed out Move
the iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during sto-
rage.
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the
plate. The resin filter is permanent and does not need replacing.
Please note: Use tap water only. Distilled and/demineralized water makes the "Zero-Calc", anti-calc
system ineffective by altering its physicochemical characteristics.
Do not use chemical additives, scented substances or decalcifies. Failure to comply with the abo-
ve-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point where no more
steam comes out, but rather drops of boiling water that can leave marks or stains. In these cases,
the Anti-drip system automatically activates to prevent vaporization, so that you can iron the most
delicate fabrics without risk of spoiling or staining them.
AUTO SHUT-OFF
An electronic safety device will automatically switch the heating element off if the iron has not
been moved more than 30 seconds in a horizontal position. If in a vertical position, this will happen
after 8 minutes. To indicate that the heating element has been switched off, the auto-off pilot light
will start blinking.
When picking up the iron again, the auto-off pilot light will turn off. The power pilot light will turn on.
This indicates that the iron is heating up again.
Wait for the power pilot light to turn off. Then the iron is ready for use.
19
Publicidad
