The triangle with a lightning symbol warns the user that high voltage is used within the device which can result
in electric shock.
The triangle with an exclamation mark informs the user that important operating and maintenance instructions
(repair) are contained in the accompanying instruction manual, which must be observed.
insTRucTiOns fOR dispOsAl
In accordance with European Directive 2002/96/EC all electrical and electronic appliances must be disposed of
separately via local collection points. Please observe the local regulations and do not dispose of your old appliances
with normal household waste.
BATTERy dispOsAl
Old batteries are hazardous waste and must be disposed of in accordance with current regulations.
cOnTEnTs
(A) 1 x active loudspeaker right (master)
(B) 1 x active loudspeaker left (slave)
(C) 2 x power cables for the active loudspeakers
(D) 1 x remote control, including battery (button cell CR2025)
(E) 1 x XLR cable (5m)
(F) 1 x USB cable (1.8m)
(G) 2 x floor plates
(H) 2 sets of fastening screws for the floor plates, including Allen key
(I) 1 x user guide (including guarantee document)
unpAcKing ThE spEAKER sET
Please unpack the speakers and accessories carefully and check the contents of the box using the list above. In the
event of any transport damage, please contact your supplier. Keep the packing material in a safe location. The original
packaging enables trouble-free transportation for any subsequent relocation and servicing requirements.
fiTTing ThE flOOR plATEs
The floor plates provided must be fitted to both speakers before use. To do this, place the speakers on a clean, stable
base with the bottom facing upwards. It is better not to remove the protective bag until after fitting has been completed
so as to avoid damage to the paint surface.
Now fit the floor plate using the M6 hexagon socket screws provided, as shown in Fig. 1. Rubber feet or metal spikes
can be screwed into the threaded inserts in the floor plate. Eight of each are provided in the package
cOnTROls fOR RighT spEAKER (mAsTER), fROnT (fig. 2)
(1) STBY/POWER:
• Red: Standby mode
• White: Operating mode
(2) Status display wireless connection right – left speaker:
• flashing slowly: Establishing connection
• permanently lit: Connection established
• off: No wireless connection, signal transmission via cable
Do not open! Risk of electric shock!
CAUTION: In order to avoid electric shock do not open the speaker housing/mains adapter or
remove the covers. The user is not to conduct any repairs him/herself. Repairs should only be
conducted by qualified technicians! Do not use any sockets or extension cables that do not
fully accommodate the plug of the device.
11