JMP Skan 8.0 Manual De Instrucciones página 7

Charger use:
Connection
1. Connect the charger power supply unit to the socket.
2. First connect the red terminal to the positive terminal on the battery.
3. Then connect the black terminal to either the negative terminal on the battery or the earth terminal on
the vehicle body.
4. Select the desired charging mode based on the battery using the selection button. Then acknowledge
with the start button.
It is recommended that the optional eyelets be used for sustained connection to the charger (e.g. for battery
trickle charging).
Disconnection
5. Following use of the charger, disconnect the link to the mains socket.
6. Then disconnect the black terminal from the negative/earth terminal.
7. Disconnect the red terminal from the positive terminal on the battery.
Battery analysis and fault signals:
Chargers are capable of checking the battery status prior to and during charging and indicating any connec-
tion faults between the charger and the battery to be charged. The following indications can appear in the
event of faults during charging:
Display message Cause
Output conductor terminals are not
connected correctly to the battery.
Possible reverse polarity.
Battery with incorrect rated voltage
(attempt to charge a 6 V or 24 V
battery).
Charger faulty.
Battery charge capacity too high.
Battery is incapable of retaining a
good charge level.
Heavily discharged battery cannot
be reconditioned.
Solution
Connect the terminals correctly and
restart charging (see "Charger use").
Check rated voltage of battery. Battery
may be faulty.
Have the charger checked by a specialist.
Use a charger with a greater charge
capacity.
Battery may be faulty.
Battery may be faulty.