Safety Considerations; Important - Dustcontrol DC Tromb 400c Manual Original

Safety Considerations

Read all instructions before attempting to operate
this machine and save these instructions.
Warning! When using electric machines, basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and personal
injury, including the following:

1. Important!

No hot particles nor ignition sources are al-
lowed to be sucked into the unit. The machine
should not be used for explosives, unstable or
pyrophoric particles or dust.
– WARNING!
be adequately instructed on the use of these
machines.
– WARNING!
dry use only.
– CAUTION!
indoor use only.
– CAUTION!
be stored indoors only.
2. Work area environment
Don´t expose the machine for rain. Don´t use
it in damp or wet locations or in presence of
flammable liquids or gases.
3. Overload
Never let the machine operate fully throttled.
Always follow the regulations pertinent to the
material you are working with ie asbestos.
Don´t use the machine for purposes that it isn´t
intended for, maximum constriction Ø 15 mm.
If the machine is at risk of overheating – e.g.
due to extreme choking – the thermo switch
will be triggered and the machine will stop. It
is important that the operator then presses the
power switch to the OFF position, removes the
plug from the power socket, and waits 3 to 5
minutes for the machine to cool. The thermo
switch can then be reset by pressing the RE-
SET button. The plug can then be reinserted
into the power socket, and the machine can be
restarted by pressing the power switch to the
ON position.
4. Body injuries
5. Don´t abuse cord
Operators shall 6. Important measure
This machine is for
7.
This machine is for
This machine shall
8. Checking for damage
9. Warning
DC Tromb 400a/c/L - 11
Never let the suction come in contact with
parts of the body. The strong suction effect
can hurt the blood-vessels in the skin. Do not
repair the electric components yourself. The
machine should be serviced by qualified per-
sonnel only. Faults may cause injury. See also
below under warnings.
Never pull the machine by the cord. Keep the
cord from heat and sharp edges. Check the
electric cable regularly for damage.
With cleaning and maintenance on the mach-
ine, the power cable should be disconnected
from the supply.
Maintain the machine with care
Keep machine clean and check that the hose
is undamaged and that all gaskets are tight.
Follow instructions. Keep handles dry and free
from oil and grease.
Before futher use of the machine it should be
carefully checked that the machine is un-
damaged. If there are any damaged parts
these should be repaired by a Dustcontrol
authorized service center.
If the supply cord is damaged, it must be re-
placed by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
Use only accessories and replacable parts
which are available in the Dustcontrol catalo-
gue. When using faulty parts or pirate parts
Part No 9480-H