Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. All electrical work and materials must comply
with the National Electric Code (NEC), the Occu-
pational Safety and Health Act (OSHA), and all
state and local codes.
2. Use copper conductors only.
3. Do not install below an electrical receptacle.
4. Do not install the heater against combustible
low-density cellulose fiberboard.
5. A heater has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or flammable vapors or liquids are used or
stored.
STEP 1
Mount Heater to Wall
1. Locate wall studs closest to supply wires and position heater
(See Figure 1). NOTE: Wire connection is possible from either
right or left side of the baseboard heater.
IMPORTANT! DO NOT DISCONNECT ANY OF THE BASE-
BOARD'S FACTORY WIRE CONNECTIONS UNTIL YOU ARE
READY TO BEGIN WIRING!
Supply
Wire
Floor
2. Remove the wiring compartment cover by removing the screw
(See Figure 2). The wiring compartment is an approved junction
box for the baseboard only. No additional junction box is required.
3. Remove the slotted knockout closest to the sup ply wires and
install a strain relief connector (See Figure 3).
INSTALLATION INSTRUCTIONS
Wall Studs
Finished
Wall
Figure 1
Wiring
Compartment
Cover
Figure 2
Figure 3
6. Heater should be set flush against surface of
the wall.
7. Remove any obstructions between the back of
the unit and the surface of the wall.
8. Baseboard heater may sit directly on any floor
surface, including carpet.
9. Maintain at least 12 inches minimum clearance
in front of baseboard, and from objects hanging
above (i.e., drapes), and 6 inches minimum on
both sides.
4. Pull supply wires through the connector and secure leaving 6
inch wire leads for later use (See Figure 4).
Supply Wires
5. Mount the heater securely to the wall with nails or screws going
into at least two wall studs (See Figure 5). The back of the heater
has "star punch" dimples that allow nails or screws to easily pierce
the sheet metal.
NOTE: You do not need to remove the front cover or disas-
semble any additional parts to mount the heater.
Wiring
Compartment
Cover
6. Connect the grounding lead to the grounding screw on which-
ever side you are wiring (See Figure 4). Both sides of the heater
include a grounding screw.
Junction
Box
Ground Screw
Figure 4
Figure 5
Page 3
Publicidad
Tabla de contenido
