Step 6:
Turn the jumping blanket upside down. Now make sure that the side of the jumping blanket, which has a hole, is
parallel to the frame tube connection. (See Figure 8)
Step 7:
Hook the rubber band over the tube
and on to the bottom of the bracket.
With the help of the clamping tool,
pull this around the pipe to the other
end and hook it onto the bracket
from below.
(See Figure 8)
Figure 9
Step 9:
Put together the remaining rubber bands with the tensio-
ning tool so that the result looks like in Figure 10.
Figure 8
Figure 10
35
Step 8:
Put together all the rubber bands as de-
scribed in step 7. Start at the corners and
proceed like the order shown in Figure 9.