Receiver Preparation (Handheld Device); Receiver Charging; Receiver Accumulator Status Check; Receiver Setting - Dog trace GPS X20+ Manual Del Usuario

7

RECEIVER PREPARATION (HANDHELD DEVICE)

7.1 Receiver charging

Receiver contains Li-Pol accumulator. Before first use,
the accumulator must be recharged.
1. Before charging clean the receiver charging contacts
from any dirt. Connect the charging clip to the
receiver (see the picture).
2. Connect supply cable to the power adapter and plug
it into the mains.
3. Lines in battery symbol start to show gradually on
LCD.
4. Charging time is approximatelly 3 hours.
5. Accumulator is charged, when the battery symbol is full – see below.
WARNING: Optimal temperature for charging is from 0°C up to 40 °C. Use only the
original power adapter supplied in the packing with the device. Other chargers
could damage the accumulator.
7.2 Receiver accumulator status
check
The accumulator status of the receiver is
indicated on the battery symbol in the
Information panel of the receiver - upper
display line.

7.3 Receiver setting

Switching receiver ON/OFF – hold the button
To choose the dog, press
To switch ON/OFF the LCD backlight, press shortly
15 minutes, after that it will switch itself off automatically.
7.4 Pairing – coding of transmitter (collar) with receiver (handheld
device)
1. Switch ON the receiver and transmitter, which you need to pair together – switch
OFF other transmitters.
2. Hold the button CODE on the receiver for 2 seconds.
3. By arrows /
(collar). Free position (where there is no paired transmitter) indicates lettering
on the LCD.
4. Hold the button CODE again for 2 seconds.
5. Bring the transmitter closer to the receiver with their RF antennas parallel to each
other.
6. When paired the LCD shows lettering
to which you´ve paired the transmitter).
/ .
choose the position, to which you want to pair the transmitter
status charge
100%
70%
40%
10%
for 2 seconds.
backlight will shine for
až (according to the choosen position,
receiver
29