Broan-NuTone RANGEMASTER 64000 Serie Manual Del Usaurio página 9

12. INSTALL THE BLOWER (INTERIOR BLOWER)
Install screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten
screws down fully, leave a 1/8" gap. Hang blower unit onto blower plate (screws through the large part of
the keyhole). Slide the blower to its position (screws in the small part of the keyhole). Tighten the screws.
HD0044
Single blower (P5)
Secure the blower by installing 2 more screws into the locations shown in the pictures below (single blower
or dual blower). Reinstall impeller(s) and cover.
HD0080
Single blower (P5)
FOR DUAL BLOWER UNIT, MAKE
SURE THE IMPELLERS
CORRECTLY INSTALLED, THE
HOOD WILL NOT WORK PROPERLY
IF REVERSED. Both impellers are
different in the dual blower, one
rotates clockwise and the other
counterclockwise. Each wheel and
motor have an arrow and a number
on them, you have to match them
correctly (see drawing beside).
Never plug the 2-prong blower cord to the 3-prong power supply cord.
Plug the power supply to the 3-prong male connector (A)
and the blower unit into the 2-prong female receptacle
(B) inside the hood.
ARE
1
HD0023
!
WARNING
- 9 -
(CONT'D)
HD0044
Dual blower (P8)
HD0081
Dual blower (P8)
FRONT
A
HE0003
2
B