Execution Of A Cooking Cycle; Troubleshooting; Routine Maintenance - Multi SCCP-72EM Guia Para La Intalación E Instrucciones De Uso

Execution of a cooking cycle

To start a cooking cycle follow the instructions below.
1. Activate and adjust the pasta cooker according to the instructions in the manual.
2. Enable the module using the switch (A).
3. Load the basket with the desired amount of product without going beyond its capacity.
4. Place the basket on the basket holder.
5. Press the C button (▼) or press the
display shows the remaining time.
6. After the set cooking time, the basket will automatically rise: the buzzer rings and LED
7. To stop a cooking cycle, press the C button (▲) or press key
automatically rise.
To set the duration of the countdown, follow the instructions below.
•
Make sure there is no ongoing countdown, and that there is no procedure in progress.
•
Press : the led
•
Press or
•
Press or do not operate for 15 seconds: the tool will exit the procedure.
To exit prematurely from the procedure, do not operate for 60 seconds.
The ascent / descent time of the basket is about 10 seconds.
The following information is intended to aid in identifying and correcting the defects and malfunctions that may occur
during use. Some of these problems can be solved by the user; the others require specific skills and therefore they must
be handled by qualified personnel.
Problem
Lift shaft blocked
The module does not work and the
green light on the main switch is off.
The module does not work and the
green light on the main switch is on.
Routine maintenance consists of the daily cleaning of all parts that may come into contact with food.
Good maintenance allows for better performance, longer equipment life and constant maintenance of safety
requirements.
Do not spray with water jets or use high pressure equipment.
GB IE
key: LED
will flash.
within 15 seconds to set the time.

TROUBLESHOOTING

Cause
Drive motor failure.
Shaft blocked.
Electrical connection is incorrect.
Timer failure.

ROUTINE MAINTENANCE

28
is turned on. Once the countdown is started, the
turns off.
: led goes off and the basket will
Remedies
Check the lifting
mechanism. Replace the motor.
Contact the service center.
Check the electrical connection.
Contact the service center.
Check the timer and its wiring.
Contact the service center.