Krups EA815 Manual De Instrucciones página 30

Adjust the size of the ground coffee by turning the 'Coffee grind setting' knob (H) in the bean hopper. We
recommend that you change the grind setting during the grinding process gradually to reach the optimum
size for your drink. After three preparations, you will notice a very distinctive difference in taste.
The grind setting is useful when you change coffee type or if you would like a stronger or weaker coffee. It is
not recommended that you perform this setting systematically.
Claris F 088 - Aqua Filter System cartridge (Sold separately)
To optimize the taste of your drinks and the lifespan of your appliance, you are advised to only use a Claris -
Aqua Filter System cartridge with your machine (see the chapter OTHER FUNCTIONS – Installing the filter).
Every time you place a Claris-Aqua Filter into the machine you must prime the filter before using the machine
by activating the "install filter cartridge" program.
MAKING AN ESPRESSO AND A COFFEE
Note :
The amount of water for making an espresso is between 1.3 and 2.3 oz.
The amount of water for making a coffee is between 2.7 and 6 oz.
Starting preparation (with 1 or 2 cups)
Press the on-off button
The coffee types menu is displayed. The function indicator
fig.6.
Place one or two cups under the coffee outlet. You can lower or raise the coffee outlet according to the
size of your cup fig.8. Select the coffee strength (shown coffee beans displayed on the screen in brackets)
with the + button to increase or the - button to decrease.
Press the navigation button
screen between brackets using the + or - buttons
Press the navigation button
between brackets using the + or - buttons
Press the START button
You can set the water volume at any time using the + or - buttons
To stop the flow into your cup, press the STOP button
You can also adjust the temperature of your coffee (see the chapter OTHER functions - Settings).
Two cup function
The appliance will automatically carry out 2 full cycles of coffee preparation.
MAKING DRINKS USING STEAM
Steam is used to froth the milk, for example when preparing a cappuccino or caffe latte, and also to heat up
liquids. As a higher temperature is required when producing steam than when making an espresso, the ap-
pliance will launch an additional pre-heating phase.
Frothing milk
For best results, you are advised to use very fresh, cold (39°F) pasteurized or UHT milk, recently opened.
Unpasteurised milk does not produce the best results.
Check that the steam nozzle is correctly positioned.
28
, and wait for the appliance to finish heating up.
to set the volume fig.10 : select the volume of water displayed on the
to set the number of cups: select 1 or 2 cups, displayed on the screen
.
fig.11.
is shown above the coffee types button
fig. 9.
.
.
.