Maintaining Your Appliance - Krups EA815 Manual De Instrucciones

Pour the milk into a milk jug which has a handle or into a cappuccino cup. Only fill it half way.
When the screen displays the drink selection menu, press the steam button
is located above the steam button
Insert the steam nozzle into the milk.
A screen indicates that the appliance is heating up. Once the appliance has finished heating up, you can begin
to make steam by pressing START
Step 1: holding the milk jug in place, insert the steam nozzle approximately 0.78 inches into the milk
and wait for it to start frothing.
Step 2: raise the container slightly (approximately 0.39 inches). Do not completely submerge the
metal tube.
Step 3: gradually lower the container as the froth accumulates fig.14.
When you have frothed the milk enough, press the STOP button
does not stop immediately.
To remove any milk traces from the steam nozzle, place a container under the nozzle and start the steam
function again (approximately 10 seconds).
The steam nozzle is removable in order to allow for deep cleaning. Wash it with water and a little non-
abrasive detergent using a brush. Rinse and dry fig.15-16. Before replacing, make sure that the air holes
are not clogged with milk residue. Unclog the holes with the needle supplied with your appliance if
necessary fig.17.
WARNING: THE CYCLE DOES NOT STOP IMMEDIATELY.
Steam can be produced for a maximum of 2 minutes per cycle.
Auto-cappuccino XS 6000 set (sold separately)
This auto-cappuccino accessory enables you to make cappuccinos or lattes fig.18. Connect the different
parts to each other. Ensure that the pipe is not pierced by keeping the knob in the correct place.
After removing the lid, fill the jug with milk fig.19 and place a cup or glass under the auto-cappuccino nozzle
(20). Select cappuccino or latte on the special nozzle fig.21.
Start steam, as indicated in the chapter Making drinks with steam.
Once you have made the frothed milk, place your cup under the coffee outlet and start a coffee cycle fig.22.
To prevent the milk from drying on the auto-cappuccino accessory, ensure that you clean it thoroughly. You
are advised to wash it immediately by running a steam cycle with the accessory jug filled with water in order
to clean the inside of the nozzle. For this you can use the KRUPS liquid detergent available separately.

MAINTAINING YOUR APPLIANCE

Emptying the coffee grounds collector, the coffee drawer and the drip tray
If the symbol starts flashing, empty and clean the drip tray and the coffee grounds collector. Do the
same for the coffee drawer fig.23-24-25.
The drip tray is fitted with floats which indicate when it needs to be emptied fig.26. Once you have removed
the coffee grounds collector, you should empty it completely in order to avoid any overflow.
The warning message will continue to be displayed if the coffee grounds collector is not pushed in or
inserted correctly. You cannot make an espresso or a coffee while the warning message is shown.
.
, and following these steps fig.13 :
fig.12. The function indicator
to stop the cycle. Warning: the cycle
29