Treating Your Body; Treating Your Face - Me Smooth Guia Del Usuario

treating your body

• Gently place the applicator on your skin, so that the two
silver RF contact bars are in complete contact with the skin.
The applicator will emit pulses of bright white light - this is
the elo ˉ s energy at work. The applicator will not work unless
both silver RF contact bars are touching your skin (3).
3
skin surface
• Glide the applicator over your skin in one continuous motion,
moving after each flash (4).
• Repeat until you have covered the entire area 2 to 3 times.
Approximate treatment times are outlined below. Individual
times may vary. You can treat all body areas during the
4
same treatment session.
1 minute 2 minutes
per underarm per bikini area
2 minutes 5 minutes
per shoulder for abdomen
Do not hold the applicator window still over one spot and flash multiple light pulses
•
on the skin. Doing so may generate too much heat which can injure the skin.
The applicator will turn itself off if it is not in use for 30 seconds. To turn the
•
applicator back on, press the elo ˉs activation button located on the applicator.
The device will go into stand-by mode after 3 minutes with no use, press the power
button to turn the device back on.
11 EN
3 minutes 10 minutes
per arm per full leg
6 minutes 12 minutes
for chest for back

treating your face

• Gently place the applicator on your skin, so that the two silver
RF contact bars are in complete contact with the skin. The
applicator will emit pulses of bright white light - this is the elo ˉs
energy at work. The applicator will not work unless both silver RF
contact bars are touching the skin.
• Allow one pulse of elo ˉ s energy on your first target area. Remove
the applicator after a single pulse and move to the next target
area. Repeat this action until you have covered your entire facial
2 minutes
treatment area.
• If you find the light from the elo ˉs pulse bright, you can wear sunglasses or
goggles for your comfort.
Do not hold the applicator window still over one spot and flash multiple light
•
pulses on the skin. Doing so may generate too much heat which can injure the
skin.
• The applicator will turn itself off if it is not in use for 30 seconds. To turn the
applicator back on, press the elo ˉ s activation button located on the applicator.
The device will go into stand-by mode after 3 minutes with no use, press the power
button to turn the device back on.
EN 12