Kygo A11/800 Manual Del Usuario página 9

E N G L I S H
Pairing
Pairing phone or devices:
•
Make sure the headphones are powered OFF.
•
Press and hold the multifunction button for 5 seconds.
•
The red and blue LEDs will blink, and you will hear a smart voice saying that the
headphones are in pairing mode.
•
Activate the Bluetooth function on your phone or device and select
Kygo A11/800 to connect.
Reconnect the last paired device:
Press the multifunction button for 2 seconds. The headphones will enter repair mode and
search for the last connected device. If it isn't connected within 10 seconds, the
headphones will enter regular pairing mode.
16
E N G L I S H
Pairing
Pairing with two phones or other devices at the same time
1. Pair with the "A" phone successfuly, then turn off the headphones.
2. Follow the same procedure with "B" phone.
3. Then power off the headphones again.
4. Power up headphones again. They will automatically connect to phone "B" (the last one
connected) and then check "found devices" on phone "A" and select Kygo A11/800 to
connect.
Pairing to a phone with NFC function
1. Make sure the NFC function on your device is activated.
2. Turn on your Kygo A11/800 headphones.
3. Put your device's NFC zone near the right side of your
Kygo A11/800 headphones.
4. If your phone asks you to confirm the connection, press YES.
Dissconnect Bluetooth
5. Press the multifunction button for 1 second. The headphones
will disconnect from the device and re-enter pairing mode.
17