Shindaiwa T261 Manual Del Propietario - Operador página 14

10/15-Hour Maintenance
Clean the spark plug
and check the gap at
0.024 inch
(0.6 mm)
Figure 29
50-Hour Maintenance
Ever y 50 hours of operation
(more frequently in dusty or dirty conditions):
n Remove and clean the cylinder
cover and clean grass and dirt from
the cylinder fins.
n Remove the cutting attachment,
cutting attachment holder and gear
shaft collar. Remove the filler plug
from the side of the gearcase and
press new grease into the gearcase
until old grease is pushed out. Use
only lithium-base grease such as
Shindaiwa Gear Case Lubricant or
equivalent. See Figure 30.
n Lubricate main shaft splines.
n Use a hooked wire to extract the
fuel filter from inside the fuel tank.
See Figure 31.
CAUTION!
Make sure you do not pierce the fuel
line with the end of the hooked wire.
The line is delicate and can be dam-
aged easily.
n Remove and replace the filter ele-
ment. Before reinstalling the new
filter element, inspect the condition
of all the fuel system components
(fuel pick-up line, fuel return line,
tank vent line, tank vent, fuel cap
and fuel tank). If damage, splitting
or deterioration is noted, the unit
should be removed from service
until it can be inspected or repaired
by a Shindaiwa-trained service
technician.
14
14
the electrode.
Figure 30
Figure 31
New
Grease
Gear Shaft
Collar
Hooked
Wire
Filter Element
Ever y 10 to 15 hours of operation:
Remove and clean the spark plug. Adjust
the spark plug electrode gap to 0.04
inch (0.6 mm). If the spark plug must be
replaced, use only an champion CJ8Y or
equivalent type spark plug of the correct
heat range. See Figure 9.
CAUTION!
Before removing the spark plug, clean
the area around the plug to prevent
dirt and debris from getting into the
engine's internal parts.
Old
Grease