Caster Or Leg Installation; Caster & Leg Mounting Detail - Delfield 400 Serie Manual De Usuario Original

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Caster Or Leg Installation - 400 & 4000 Series
1. Carefully place the unit on its back (see illustration at right).
2. Located at each caster mounting location are 4 Phillips head
screws, for a total of 16 screws. Remove them.
3. Place a locking plate caster or leg over one of the front holes,
matching the 4 mounting holes to the pre-drilled holes in the
underside of the unit. Insert 4 Phillips head screws and tighten.
Repeat with the other locking front caster or leg.
4. Repeat step 3 with the non-locking casters or legs in the rear
of the unit.
5. Carefully lift the unit upright.
After installing casters or legs, the unit must stand
upright for
twenty-four (24) hours before being
powered up to assure oil return to the compressor
WARNING
sump.
2", 3" and 5" Caster and Leg Mounting Detail
A universal bolt hole pattern is provided on the bottom of the cabinet. It will accommodate any leg or caster. Simply line up the plate
holes with the corresponding cabinet holes.
2.38"
6cm
3.40"
9cm
NOTE:
If hole pattern on caster/leg
matches the one above mount in
outer set of holes.
6" Leg - 3234569
International Work Top & Undercounter Refrigerators & Freezers Original User Manual
1.75"
4cm
2.82"
7cm
NOTE:
If hole pattern on caster/leg matches
the one above mount in middle set
of holes.
3" Caster - 3234024
5" Caster - 3234161
6" Leg - 3234791
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
Plate Casters
W/Locks
Plate Casters
W/O Locks
Screws
Plate caster installation, 400 & 4000 Series.
0.94"
2cm
2.14"
5cm
NOTE:
If hole pattern on caster/leg matches
the one above mount in inner set of
holes.
2" Caster - 3234148
7

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido