Publicidad
2
Carefully lift tunnel
assembly and position it
at the desired location
making sure it is level.
Press firmly for 10
seconds at each clip
location along the
length of the assembly
to secure the clips
and clip
22
3
21
21
22
to the wall.
22
21 22
21
21
21
4
Peel the tunnels
away from
23
the clips
21
and
22
.
21
23
22
23
23
Arrange your wires on either
side of the clips.Reattach the
tunnels
to the clips
23
and clip
making sure
22
to capture the wires behind
them. Press firmly along the
length of the tunnels where
the clips are located until clips
snap in place.
NOTE: Leave enough
slack in the cables/wires above
the tunnel to prevent them from
interfering with or rubbing against
the tunnel when moving the TV. This
could cause the tunnel to separate
from the clips.
TIP: Taping the cables/wires in
place above and below the tunnels
to hold them will make reattaching
the tunnels easier.
21
Publicidad
