Maintenance & Care - Mettler Toledo 3390 GageMount Manual Del Usario

5 Maintenance & Care
As dust deposits cause heat accumulation on open surfaces and could thus become flammable
As dust trapped between moving parts can become an ignition hazard.
If necessary observe maintenance intervals and check for proper functioning of the system including options and accessories.
See 2.2. above.
Clean non-conductive parts with a damp cloth only, to avoid electrostatic charging. This applies in particular to weigh module labels and
accessory pads (Shock/Vibration, Acetal and PEI pads) and load cell accessories EVK, EVKT, EVK FL, FTK and FTKT.
Highlight this danger with a warning label that states "Non-conductive parts, clean only with a damp cloth" attached to the parts. Add this
warning statement also to any work instructions and to any on-site explosion protection documents.
5
30104376C Installation Instructions Maintenance & Care