Temperature Setup; State Of Goal Object Setup - Gram FD Serie Manual De Utilización

4. Press
mode.

TEMPERATURE SETUP

1. Press
2. Press
temperature value set last time displays). If the referential liquid's
measured temperature is lower than the displayed temperature, press
key to reduce till the reading is same as the referential liquid's
measured temperature. If the referential liquid's measured temperature
is higher than the displayed temperature, press
the reading is same as the referential liquid's measured temperature.
3. After setting up temperature, press
key for confirmation, Temperature Setup is over.

STATE OF gOAL ObjECT SETUP

Before density measurement, please set up the State of Goal Object, steps
are as follows:
1. Press
2. Press
3. Press
Remarks:
If measuring solid's density, press
(3), State of Goal Object Setup is over; If measuring liquid's density,
20
key for confirmation, balance can be back to normal weighting
key, "CEnTIg" displays.
key, default "20" temperature value displays (or the
key, "CEnTIg" displays;
key, "ShAPE" displays;
key, "SOLID" displays;
key to increase till
key, value flickers, press
key for confirmation after step