Replacing Components - Virtus 70/40 IND Serie Instalación, Uso, Mantenimiento

Defective
temperatu
re heating
coil
ERROR MESSAGE
Water or
cookware
Key pad
permanen
E2 <-> 03
tly on
Key button
connectio
Wiring
n between
interruptio
n
generator
E2 <-> 10
Faulty ID
faulty ID
diagnosis
Self
diagnosis
E2 <-> 11
software
error
The device
Invalid found no
E2 <-> 13 configurati
on data confgurati
Problem
Supply
E2 <-> 14
voltage
voltage of
The sensor must
be replaced
CORRECTIVE
CAUSE MEASURE
Clean control
on the
area
control
glass
Replace digital
defect control unit
Faulty
Replace
key pas connecting cable
and
Switch the
Digital
generator
control
off,adjust the
has a
DIP-switches
correctly
Self Switch the
power off and
of on, if the error
remains contact
located customer
error support
Contact
valid customer
support
on data
with
Automatic reset
supply
the key
Unknown
E2 <-> FF
error
16.

REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
WHEN REPLACING THE RADIANT
HOTPLATES, HANDLE AND REASSEMBLE
PARTS WITH THE UTMOST CARE.
REPLACING THE HOB INDUCTOR ELEMENT
Remove the control panel and front.
Remove the component and disconnect it.
Replace the faulty component.
REPLACING THE WOK INDUCTOR ELEMENT
Disconnect the inductor from the terminal board
located on the generator.
Remove the inductor, lifting it downwards.
Replace the faulty component.
REPLACING THE TEMPERATURE REGULATOR
Remove the control panel.
Replace the faulty component.
REPLACING THE GENERATOR
Remove the control panel and front.
Remove the generator and disconnect it.
Replace the faulty component.
24
pad
An error
Contact
occurred,
customer
its cause in
support
unknown