Attaching The Blades; Switch Cup - Home Depot Home Decorators Collection 51560 Guía De Uso Y Cuidado

Assembly - Attaching the Fan Blades (continued)
2

Attaching the blades

Your fan blades are reversible. Select the blade side finish
which best accentuates your decor.
Mount the fan blades (G) to the blade bracket (F) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (F).
Hold the blade (G) with both hands close to the blade bracket
(F) and press the blade (G) down firmly. Ensure the key-slot
holes are properly seated on the blade arm posts.
While still holding the blade (G) down with both hands, firmly
slide the blade (G) away from the fan-motor assembly (E) until
the blade (G) engages in the locking mechanism. Make sure
the steel locking mechanism at the rear of the blade bracket
(H) springs upward and snaps into place against the edge of
the blade (G) indicating a secure connection.
Visually inspect the top of the blade bracket (F) to ensure the
locking mechanism is securely in place.
Repeat for the remaining blades (G).
Assembly - Installing the Switch Cup
1
Installing the switch cup
Remove one screw (TT) from the black bracket below the fan
motor assembly (E) and loosen, but do not remove the other
two screws.
Push the switch cup (H) up to the fan motor assembly (E) so
the two loosened screw heads fit into the keyhole slots. Turn
the switch cup (H) clockwise to secure.
Re-install the screw (TT) that was removed in step 1.
Make sure all the screws are firmly tightened.
E
H
TT
13
Please contact 1-800-986-3460 for further assistance.
E
G
HOMEDEPOT.COM/HOMEDECORATORS
F