Allen + Roth WSWS-CS1C Manual De Usario página 8

ASSEMBLY INSTRUCTIONS
Wall Hanging Installation
21. Using a stud fi nder, locate the edges of the wood
studs. Find the center line of each stud and draw a
vertical reference line on the wall over each one. Position
installation template (W) at desired location on wall.
Note: The bottom of the installation template (W) should
be no less than 31-1/2 in. from the fl oor.
Mark mounting holes with a pencil (not included) and
discard installation template (W). Drill 3/16 in. pilot holes at
marked locations. Then, with the beveled edge facing up,
attach the wall hanging cleats (O) with large fl at washers
(QQ) and lag bolts (PP).
Hardware Used
M8 x 2-1/2 in. Lag Bolt
PP
QQ
Large Flat Washer
22. With the help from another person, carefully
hang the unit onto wall hanging cleat (O).
21
16 in.
O
39-1/2 in.
W
O
Minimum 31-1/2 in.
x 4
x 4
22
O
O
O
Lowes.com/allenandroth
14
ASSEMBLY INSTRUCTIONS
Long Shelf Installation
Note: If long shelf (V) needs cut to fi t inside your closet
space, cut only one side of the shelf and do not use
QQ a hacksaw. It is recommended you hire an insured
remodeler for this type of installation.
PP
23. With a pencil, draw a level line at the desired
mounting location for long shelf (V). Using L-brackets
(SS) as a guide, mark the screw hole locations with a
pencil. Drill 3/8 in. diameter pilot holes at least 2-1/2 in.
deep at marked locations, then insert wall anchors
QQ
into the holes until they are fl ush with the wall. Attach
L-brackets (SS) to the wall using M4 x 38 mm screws
PP
(KK) and to the long shelf (V) using M4 x 14 wood screws
(MM).
Hardware Used
KK M4 x 38 mm Screw
MM M4 x 14 mm Wood Screw
RR
Wall Anchor
SS L-Bracket
24. Attach long shelves (V) to hutch panel left (A)
and hutch panel right (B) with L-brackets (SS),
securing with M4 x 14 mm wood screws (MM).
Hardware Used
MM M4 x 14 mm Wood Screw
SS
L-Bracket
23
V
(RR)
KK
MM
x 8
x 8
x 8
x 4
24
SS
x 16
x 4
Lowes.com/allenandroth
15
RR
SS
V
MM