Panasonic BB-HCA10CE Guia De Instalacion página 5

9. Attach the connector cover (included) and
connect the necessary cables to the camera.
• Align the " " of the connector cover with the
center of the recessed area of the bracket.
• Cut spaces in the connector cover to make
room for the cables that will be connected to
the camera. Cut along the perforated lines.
Recessed area
10. Attach the camera to the bracket in 3 places
using screw B (included).
• Align the arrows on the ceiling plate (included
with the camera) and the bracket when
attaching the camera.
Ceiling plate arrow
11. Secure the ceiling mounting cover (included) to
the bracket.
1 Pass the safety wire through the ceiling
mounting cover as shown.
2 Align the " " marks on the rear of the camera
and on the ceiling mounting cover.
Camera direction
3 Turn the ceiling mounting cover clockwise
until the " " mark on the rear of the camera
and the " " mark on the ceiling mounting
cover are aligned as shown.
• Be careful not to nip the cables, cords, etc.
• To remove the ceiling mounting cover, turn it
counterclockwise until the " " mark on the rear
of the camera and on the ceiling mounting
cover are aligned, then lower the ceiling
mounting cover.
12. Secure the safety wire to the ceiling.
• Secure the bracket's safety wire first, using
screw A and the washer (included with the
bracket), then secure the camera's safety
wire, using screw A and washer A (both
included with the camera).
• Secure the safety wires to the ceiling about
160 mm from the center of the camera.
• Do not drive the screws into a soft material.
Drive the screws into a secure, 25 mm thick
area of the ceiling, such as a crossbeam,
otherwise the bracket and the camera may
fall. If there is no crossbeam, place a board on
the other side of the ceiling to make sure the
bracket and the camera are securely
mounted.
Washer
(Inside diameter:
4.0 mm)
Screw A
(Length: 20 mm,
Body diameter: 4.0 mm)
Specifications
Operating +0 °C to +40 °C
temperature
Dimension About 270 mm × 77.5 mm × 270 mm
(W×H×D)
Weight About 900 g
Washer A
(Inside diameter: 4.0 mm)
Screw A
(Length: 20 mm,
Body diameter: 4.0 mm)
5