Room Temperature Settings - NUK Eco Control Video Display 550VD Manual Del Usuario

6. Use the 25 or
star in front of "LCD Auto Off".
7. Press the button 26 to view the next
submenu.
5 Min: The screen will switch itself off
after 5 minutes.
1 Min: The screen will switch itself off
after 1 minute.
OFF: The screen will remain on.
The active setting will be shown in green.
8. Use the 25 or
star in front of the required time.
9. Press the button 26 to confirm your
setting.
The setting will be stored, the menu will
be closed, and the parent unit will return
directly to monitoring mode.
Note: If Eco-Mode is active while the screen
is switched off, you can still change a set-
ting in the main menu, but the screen will
otherwise be white, as video transmission is
deactivated in Eco-Mode. This is no cause
for concern - the device is still working as
intended. It simply means that Eco-Mode
has paused the video transmission because
your baby is asleep (see "4.5 Eco-Mode and
Full-Eco-Control" on page 52).
6.10 Room temperature
settings
The correct room temperature is particularly
important for baby's healthful sleep. The
baby unit of this NUK baby monitor there-
fore has an integrated temperature sensor.
The temperature in baby's room is perma-
nently shown on the screen 19 and updated
automatically.
Note: Since the temperature sensor is inside
the baby unit it is important that you do not
cover it or place it near a heater. Direct sun-
light may also affect the reading.
The baby unit
temperature and sends an alarm to the
parent unit when the set temperature limits
are exceeded.
28 button to move the
28 button to move the
monitors the room
Setting the temperature unit °C or °F:
1. Press the
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the
select the Temperature menu.
The selected symbol will be shown in red.
3. Press the
menu.
The temperature submenu has three set-
tings you can adjust:
°C/°F: Allows you to choose the unit of
temperature shown in the status bar of
the parent unit.
LIMIT: Allows you to set the upper and
lower limits for the temperature alarm.
ALARM: Allows you to enable and disa-
ble the temperature alarm when the room
temperature rises above or falls below
the set limits.
4. Use the 25 or
star in front of "°C/°F".
At this point, you can still exit the sub-
menu by pressing the
submenu will close and you will be
returned to the previous submenu. How-
ever, to continue with your settings, con-
tinue with the next step.
5. Press the
submenu.
The active setting will be shown in green.
6. Use the 25 or
star in front of the required unit of tem-
perature.
At this point, you can still exit the sub-
menu by pressing the
submenu will close and you will be
returned to the previous submenu. How-
ever, to continue with your settings, con-
tinue with the next step.
7. Press the
setting.
65
button 26.
24 or 27 button to
button 26 to view the sub-
28 button to move the
button 27. The
button 26 to view the next
28 button to move the
button 27. The
button 26 to confirm your