Display + Controls - EcoxGear EcoXplorer GDI-EXPLR100 Manual De Instrucciones

Display + Controls

9
10
11 12
7
8
6 5
13 4 3
7 2 1
TOP
1. Standby Power Button:
Turns EcoXplorer On/Off. Main Power Switch (located
behind waterproof cap) must be set to ON for Standby Power function to operate.
2. Play/Pause/Answer:
Press to play or pause a track and to answer mobile calls
from a paired Bluetooth device.
3. LED Battery Level Indicators:
full LEDs indicate a full charge.
4. Track Buttons:
Press these buttons to go to the previous/next track on a paired
Bluetooth device.
5. EcoConnect Button:
If you have purchased a second EcoXplorer (or one other
ECOXGEAR speaker bearing the EcoConnect symbol), press and release this button
on both speakers to link them together and play in stereo. The LED Indicator above
the button will shine blue.
6. Bluetooth Button:
When in Bluetooth mode, if the LED indicator above this
button is not slowly flashing blue, press this button to enter pairing mode. The
LED Bluetooth Indicator will shine solid blue when the EcoXplorer is paired to your
device. If your device is paired, press this button to disconnect. Press and hold this
button for 5 seconds to clear all pairing records.
7. Master Volume Control:
Press to adjust the speaker's main volume. Press and
hold to adjust the volume continually (volume levels are 0 to 15).
8. Microphone Volume Control:
and hold to adjust the volume continually (volume levels are 0 to 8).
9. Tune Buttons:
Press these buttons to tune in a radio station. To "seek" (jump
to the next available station), press and hold either button down for a few seconds
until it starts to seek a station.
10. AM/FM Presets:
Store up to 6 of your favorite AM/FM radio stations and
quickly tune to a preset radio station. PRESS AND HOLD to program presets.
11. Source Button:
Press this button to cycle through the following modes: BT
(Bluetooth), AUX, FM, and AM.
12. EcoTalk:
This button activates your Voice Assistant (Siri and OK Google) on the
paired device.
13. LED Screen:
Indicates that the unit
has been turned On.
Indicates that the unit
has been turned Off.
The EcoXplorer is in
Bluetooth mode.
The EcoXplorer is in
AUX mode.
Each LED represents 25% of a full charge. Four
Press to adjust the microphone volume. Press
The EcoXplorer is in
FM mode.
Indicates the current FM
station of the EcoXplorer.
The EcoXplorer is in
AM mode.
Indicates the current AM
station of the EcoXplorer.
8