Parkside PABK 60 B3 Instrucciones De Utilización Y De Seguridad página 28

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 88
Never use a device with a switch
that is defective. A device that
can no longer be switched on
and off is dangerous and must
be repaired.
Store the idle pneumatic device
out of the reach of children. Do
not let anyone use the device who
is not familiar with it or has not
read these instructions. Pneumatic
devices are dangerous when
they are used by inexperienced
people.
Maintain the device with care.
Check that moving device parts
are working properly and move
freely. Check for any parts that
are broken or damaged enough
to detrimentally affect the func-
tioning of the device. Have dam-
aged parts repaired before using
the equipment. Many accidents
have their origins in poorly main-
tained devices.
Turn the device off when it is no
longer in use.
Wear personal protective
equipment and always
wear protective glasses. Wear-
ing personal protective equipment
such as a dust mask, non-slip
safety shoes, a safety helmet or
ear protectors, depending on
the type of pneumatic tool and
285126_Airbrush-Set PABK 60 B3_content_OS.indd 25
General safety instructions for pneumatic tools
its application, reduces the risk
of injuries.
Test the connections and the
supply cable. All maintenance
units, couplings and hoses must
be designed in accordance with
the device's values with regard
to pressure and air quantity.
Pressure that is too low impairs
the functioning of the device;
pressure that is too high can
cause damage to property and
personal injury.
Protect hoses from kinks, con-
strictions, solvents and sharp
edges. Keep hoses away from
heat, oil and rotating parts.
Ensure that the hose clips are al-
ways firmly attached. If the hose
clamps are not tightly fastened
or are damaged, the air could
escape uncontrollably.
Replace damaged hoses imme-
diately. A damaged supply line
may result in the air hose whip-
ping about and may result in
injuries.
If the power cable of the appli-
ance is damaged, it must be
replaced by the manufacturer
or their service department or a
similarly qualified person, in
order to avoid hazards.
GB/IE
25
19.06.17 16:14

Publicidad

Tabla de contenido
loading

Tabla de contenido