V2 CU1 Manual Del Usuario página 20

ARTEMIS SERIES TRANSMITTERS
Using a transmitter of the ARTEMIS series you can change the
functions of the control unit that drives the tubular motor.
L1
L1 L2
UP
STOP
DOWN
L1 L2 L3 L4 L5 L6
UP
STOP
DOWN
FAST PROGRAMMING
RAPID TRANSMITTER DATA STORAGE
m
CAUTION: The data storage of the first transmitter
determines the direction of motion of the motor.
m
CAUTION: If the awning has a casing carry out the data
storage of the first remote control by following the procedure
"TRANSMITTER DATA STORAGE"
UP
To store your remote controls on a virgin control unit which
drives a shutter or an awning (WITHOUT casing) proceed as
follows:
STOP 1. Supply power only to the control unit to be programmed
2. Activate the programming by following one of these
procedures
DOWN
Artemis with 1 channel:
• Press and hold down the UP+DOWN keys until the motor
starts to move in one direction
Artemis with 2 channels:
• Press the UP+DOWN keys of one of the two channels until
the motor starts to move in one direction
Artemis with 6 channels:
• Select the channel to be programmed with the C key
• Press the UP+DOWN keys until the motor starts to move in
one direction
3. Release the keys: the motor stops
UP
4. Press the UP or DOWN keys according to the direction in
which the roll-up shutter was moving before it stopped:
- if the roll-up shutter was being raised press the UP key;
STOP
direction obtained: the UP key raises the roll-up shutter,
the DOWN key lowers the roll-up shutter
- if the roll-up shutter was being lowered press the DOWN
DOWN
key; direction obtained: the DOWN key lowers the roll-up
shutter, the UP key raises the roll-up shutter.
5. Programming is complete
To add additional remote controls, proceed as follows:
6. Press and hold down the UP+DOWN keys of a remote control
which has already been programmed until the motor starts to
move in one direction
7. Release the keys: the motor stops
8. Press the UP or DOWN key of the new remote control
SUN ON
ACTIVATION OF THE SUN SENSOR ON A
CONTROL UNIT
SUN OFF
Press and hold down the STOP+UP keys until the motor confirms
the operation by moving in both directions.
C
DEACTIVATION OF THE SUN SENSOR ON A
CONTROL UNIT
Press and hold down the STOP+DOWN keys until the motor
confirms the operation by moving in both directions.
- 20 -