Atomic G01342W Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

20 pcs - H4 Phillips Round Head Screw
2 pcs - P2 End Apron
STEP 8:
Attach P18 Plastic Brackets onto the back side
of P2 End Apron using pre-drilled pilot holes
with H4 Screws as shown in FIGURE 8.
Tighten, but do not strip out H4 screws.
NOTE: Be sure bottom edge of P18 Plastic
Brackets is flush with bottom edge of apron.
Attach P8 Top Goal Box and P9 Bottom Goal
Box onto the back side of P2 End Apron using
pre-drilled holes with H4 Screws as shown in
FIGURE 8.
Tighten, but do not strip out H4 screws.
Repeat procedure for second assembly.
STEP 9:
Attach previous assemblies from STEP 8 to the end of table cabinet using pre-drilled pilot holes with H7 Screws
as shown in FIGURE 9. Tighten, but do not strip out H7 screws.
Install H4 Screws into previously installed P18 Plastic Brackets as shown in FIGURE 9.
Tighten, but do not strip out H4 screws.
STEP 8
Assembly
H4
All Rights Reserved.
© 2012 Escalade Sports
PARTS REQUIRED:
PARTS REQUIRED:
8 pcs - H4 Phillips Round Head Screw
12 pcs - H7 Phillips Flat Head Screw
H4
P18
P5
2 pcs - P8 Top Goal Box
2 pcs - P9 Bottom Goal Box
FIGURE 8
NOTE:
Ball Opening
in P2 End Apron
must be in this
position.
P9
P2
FIGURE 9
10
4 pcs - P18 Plastic Bracket
H4
H4
P18
P8
NOTE:
Opening of P9 Bottom Goal
Box must be in this position.
C2
H7
STEP 8
Assembly
For Customer Service Call 1-888-996-2729
H4
P18
H7

Publicidad

Tabla de contenido
loading

Productos relacionados para Atomic G01342W

Tabla de contenido