Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 6:
Peel the protective coating off P12 Playfield Trims, then peel the adhesive strip protective film off the underside
of P12 Playfield Trims. Turn them over and carefully place them along P1 Side Aprons as shown in DETAIL B
and FIGURE 6.
Peel and Turn Over
DETAIL B
NOTE: Adhesive
strip this side.
PARTS REQUIRED:
18 pcs - H5 Phillips Washer
Head Screw
1 pc - P4 Playfield
STEP 7:
Place P4 Playfield with graphics
facing down onto the main cabinet.
Align P4 Playfield holes with P12
Playfield Trims holes and attach
using H5 Screws as shown in
FIGURE 7.
Tighten, but
do not strip out H5
Screws.
Graphic
facing down
IMPORTANT NOTE:
P4 Playfield must be evenly
spaced on top of both ends
of P6 Goal End Board - at each
end of cabinet assembly.
P1 Side Aprons may be slightly
warped. Please keep P1 Side
Aprons pushed in tight against
the P4 Playfield for correct assembly.
All screws must be screwed
STRAIGHT down.
All Rights Reserved.
© 2012 Escalade Sports
PARTS REQUIRED:
2 pcs - P12 Playfield Trim
P12
P4
FIGURE 7
P6
9
FIGURE 6
P12
H5
For Customer Service Call 1-888-996-2729
P1
P6
Publicidad
Tabla de contenido
