Descargar Imprimir esta página

Unpacking And Content; Assembly & Adjustment - POWER SMITH PWLR1110M Manual Del Operador

Publicidad

Idiomas disponibles

Idiomas disponibles

UNPACKING AND CONTENT

IMPORTANT
faulty or that a part is missing. If you find anything wrong, do not operate the product until the
parts have been replaced or the fault has been rectified. Failure to do so could result in serious
personal injury.
CONTENTS IN PACKAGE
Description
Work light
Stand
120V AC Power Charger
ASSEMBLY & ADJUSTMENT
ATTACHING THE WORK LIGHT HEAD TO
THE STAND (FIG 2)
This work light comes with a reversible stand. It can stand either on the
magnetic feet or on the rubber feet by flipping the stand over. See FIG 2.
To Install the Work Light Head on the Stand
1. Place the stand (9) on a flat surface.
2. Position the U-Shaped bracket (3) of the work light head against the
stand (9) as shown in FIG 2.
3. Use the locking knob (6), flat washer and spring washer to secure the
work light head on the stand.
CHARGING/RECHARGING THE WORK LIGHT (FIG 3)
This rechargeable work light is shipped with the battery partially charged. Charge the work light after purchase and
before first use by using the 120V AC charger (11) for 3-5 hours or until the battery charge indicator turns green.
Charging/Recharging Using the 120V AC Charger
1. Make sure the work light is off.
2. Connect the 120V AC power charger and the work light
as shown in FIG 3.
3. Insert the plug end of the AC charger into a standard
120V/60Hz power outlet to start charging. A lit red light
on the charger indicates the charging is in progress.
The charge indicator turns green when the charging is
completed.
Charging/Recharging Using the 12V DC Car Charger
1. Make sure the work light is off.
2. Connect the 12V DC charger and the work light as shown in FIG 3.
3. Insert the 12V DC plug into the accessory outlet of a vehicle or other 12 volt DC power outlet to start charging. A lit
red light on the charger indicates the charging is in progress. The charge indictor turns green when the charging
is completed.
!
Due to modern mass production techniques, it is unlikely the product is
QTY
1
1
1
OPERATION
English
Description
12V DC Car Charger
Operator's Manual
4
QTY
1
1
A
B
FIG 2
13
12
FIG 3
11

Publicidad

loading