Autopilot APCL4DX Manual De Instrucciones página 4

OPTIONAL CONNECTION FOR USE WITH THE
AUTOPILOT PX1 DIGITAL LIGHTING CONTROLLER
LOW VOLTAGE TRIGGER
To the left of the trigger terminal block is a loop of wire labeled TRIGGER, which is factory installed.
Removing this wire and connecting the two terminals to a set of dry relay contacts, like those used on
the Autopilot PX1, allows you to control the APCL4DX/APCL8DX with your PX1 Lighting Controller.
NOTE: In order for this unit to work with the PX1 Digital Lighting Controller, the 120V trigger cable
must be plugged into a 120V power source at all times.
The low voltage connection is only 5 Volts, and is suitable for connection to the PX1 controller. Short
the two terminals together, and the APCL4DX/APCL8DX turns on. Open that loop, and the APCL4DX/
APCL8DX turns off.
4-LIGHT CONTROLLER (APCL4DX)
LOW VOLTAGE TRIGGER CONNECTION
www.Hydrofarm.com
4
INSTRUCTIONS
4-LIGHT (APCL4DX) SPECIFICATIONS
Main Power Voltage
Receptacle Type
Maximum Lighting Wattage
Maximum Relay Amperage
Operating Temperature Range
Operating Humidity Range
Minimum Relay Operations
8-LIGHT (APCL8DX) SPECIFICATIONS
Main Power Voltage
Receptacle Type
Maximum Lighting Wattage
Maximum Relay Amperage
Operating Temperature Range
Operating Humidity Range
Minimum Relay Operations
8-LIGHT CONTROLLER (APCL8DX)
LOW VOLTAGE TRIGGER CONNECTION
120V or 240V
4 Nema 6-15 or universal
4000W (1000W per outlet)
30A
32‒110°F
0-99% RH non-condensing
100,000 @ full load
120V or 240V
8 Nema 5-15, Nema 6-15 or universal
8000W (1000W per outlet)
30A x 2 relays - 60A total
32‒110°F
0-99% RH non-condensing
100,000 @ full load