Nursery Unit Set Up; Parents Unit Set Up; Testing Our Angelcare® Monitor - Angelcare Platinum edition AC1100 Manual De Instrucciones

Ocultar thumbs Ver también para Platinum edition AC1100:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
MANUEL AC1100 INTERNATIONAL_Manuel AC1100 11-03-28 1:03 PM Page 4
STEP 2 - Nursery Unit set-up
Push button
POWER
On/Off wing
Video
camera
Microphone
STEP 3 - Parents Unit set up
N
STEP 4 - Testing your Angelcare
• Test your monitor BEFORE using it for the first time
• The Angelcare Monitor can be used with the factory settings or you can modify them in the menu.
Note: Test your Angelcare® monitor BEFORE using it for the first time and then on a regular basis to make sure that it is functioning properly.The Angelcare® monitor can be used
outside of the crib in a different sleeping area.Test your monitor when moving the Sensor Pad to a new location to ensure sensitivity is adjusted correctly to the new padding or
mattress. Refer to the movement sensitivity adjustment section.
1.TEST THE SOUND Make sure the sound mode is ON. Have someone else speak into the Nursery Unit or place a radio near the Nursery Unit. You should hear sound from the
Parents Unit. If there is no sound,refer to the Troubleshooting section.
2.TEST YOUR MONITOR TO DETECT MOVEMENT Make sure the Sensor Pad's cord is plugged into the Nursery Unit then turn both units ON. Make sure the movement function is
ON. Gently move your hand on the mattress.The pendulum symbol will move with your every movement. Remove your hand from the mattress. Due to the lack of movement, a
pre-alarm "Tic"sound will be emitted after 15 seconds and 5 seconds later, the alarm will sound.
Speaker
Night light
Night light
ON/OFF
4 Infrared LEDs
Power indicator
LED (green)
Low battery indicator
LED (red)
•Remove the belt clip and insert 3 AAA NIMH rechargeable
batteries (included) into Parents Unit. NEVER use regular
alkaline batteries, they may explode.
• Connect AC adapter to Parents Unit charger and plug
adapter into an electrical outlet. Let charge for 15
continuous hours before using the monitor for the
first time.
Speaker sound UP
Speaker sound DOWN
Press and hold for MUTE
Talk - Press and hold
®
monitor
Sensor Pad
cable entry
AC adapter entry
Rotating knob for
camera angle
Back up battery
compartment and
Tripod connector
POWER On/Off
Speaker
4
ACTIONS
•Connect the Sensor Pad cord to the
Nursery Unit.
• Insert 3 AAA regular batteries (not
included) in the Nursery Unit (for battery
backup in case of power failure).
• Connect AC adapter to Nursery Unit and
plug adapter to an electrical outlet in the
baby's room.
• Push and hold the left wing for 2 seconds
to put the Nursery Unit power ON.
LCD Touchscreen
Microphone
ACTION
Leave on charger for 15 continuous
hours before using your monitor.

Publicidad

Tabla de contenido
loading

Tabla de contenido