Setting Up The Nursery Unit; Turning On Your Monitor - Angelcare AC027 Manual Del Propietário

IMPORTANT
• If your crib does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hardboard between the crib base and the Sensor Pad, to ensure correct
operation. The hardboard support must measure at least 30 x 30 cm
(12" x 12") and 6 mm (1/4") thick. This hardboard support must be larger
than the Sensor Pad surface area
• The Sensor Pad functions with standard crib sprung and foam
mattresses and not memory foam (partial or full), hollow frame
construction mattresses and water beds. Please consult Angelcare if
unsure of mattress compatibility. The hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby's movements even when the baby
is at the edges of the crib

2- SETTING UP THE NURSERY UNIT

Sensor Pad

3- TURNING ON YOUR MONITOR

+ -
Place the
Nursery Unit at least 3
feet (1 meter)
from the crib
Note:
• The Nursery Unit will emit a sound and flash blue
to confirm pairing with the Sensor Pad
• If the green light does not appear but the red
light is flashing; or if there are false alarms,
adjust the sensitivity level (STEP 3, TEST THE
SENSOR PAD)
E
N
5