Step 2A, Ro Water Line; Step 3, Install Side Panels; Step 4, Install Anti-Tip Brackets; Precautions - GE Profile PSB42LGRWV Instrucciones De Instalación

2A WATER LINE
INSTALLATION WITH A
REVERSE OSMOSIS SYSTEM
SKIP THIS STEP WHEN NOT USING AN RO SYSTEM
NOTE: If the water supply to the refrigerator is from a
Reverse Osmosis Water System, use the refrigerator's
filter bypass plug. Using the refrigerator's water filtra-
tion cartridge with the RO filter can result in hollow
ice cubes.
• Open the top grille to view the filtration cartridge.
Master
Power Switch
Rotate Counterclockwise
Rotate the filtration cartridge counterclockwise until
removed.
• Insert filter bypass plug. Rotate the filter bypass plug
clockwise until tightly secured in place.
3 INSTALL SIDE PANELS
SKIP THIS STEP WHEN NOT USING SIDE PANELS
If you are using 1/4" side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with the 3M Dual Lock adhesive strips
before setting refrigerator in place.
4 INSTALL ANTI-TIP BRACKETS
WARNING:
The refrigerator is Top-Heavy and must be secured to
prevent the possibility of tipping forward.
• Cut a 2" x 4" wood block 36" long,
and secure the block
to the mounting
brackets pro-
vided, using #12
or #14 wood screws.
• Secure the brackets
with wood block to the
back wall so that it is
82" (or the rear installa-
tion height) from the finished floor.
Use #12 or #14 wood screws.
• Screws must penetrate at least 1" into vertical
wall studs.
Installation Instructions
Water Filter
To Remove
ANTI-TIP

PRECAUTIONS

36"
Positioned
Wood Screws
Mounted into
Vertical
Wood Studs
4A ALTERNATE ANTI-TIP
PRECAUTIONS
SKIP THIS STEP WHEN USING ANTI-TIP BRACKETS
All Profile built-in refrigerators are Top-Heavy.
They must be secured to prevent the possibility of
tipping forward. Use this alternative method to
secure the refrigerator whenever steel wall studs
are encountered.
• Adjust height of refrigerator to match installation
cutout opening 83-1/2" to 84-1/2". The refrigerator
must be level and plumb with cabinets. The top
case trim at the front is 2-1/8" higher than the rear
and will overlap upper cabinets or cabinet trim.
• Open grille panel to access the top case trim.
• Use a 3/16" bit to drill 4 evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16" bit to drill pilot holes through the
metal clearance holes and into wood soffit. The
holes should be centered in the soffit or a 3/4"
minimum wood brace. The brace spanning the
enclosure must be securely fastened to cabinets
on both sides.
• Install four 1-1/2" drywall screws into the pilot holes.
Anti-Tip
Bracket
Wall Stud
(Behind
Drywall)
15
Top Case Trim
Install (4) 1-1/2" Drywall Screws
Through Trim and Into Soffit
or 3/4" Min. Wood Brace
3/4"
Min.
Side View
Top Case Trim